PAM-IP Range
Note: A factory reset will remove all presets so make sure to save your presets to a USB drive should you wish to re-upload them after the procedure. Fo...
Tue, 7 Apr, 2020 at 10:33 AM
All Dante/AES67 sources routed to the PAM1-IP-3G PAM2-IP-3G must be made using Dante Controller. Ensure a CAT5 cable is connected from the Dante port at the...
Tue, 7 Apr, 2020 at 3:34 PM
The PAM1-IP-3G and PAM2-IP-3G audio monitors can monitor uncompressed SMPTE 2022-6 and 2110 Multicast IP streams when equipped with optional SFP modules. ...
Tue, 7 Apr, 2020 at 12:30 PM
Software updates for your PAM2-IP are available in the TSL products audio support page, under 'Latest Software Releases" as seen below: https:...
Wed, 15 Apr, 2020 at 9:29 AM
You can choose whether to monitor via NMOS or Ember+ on a Embrionix ST2110 Stick by navigating into its IP address on a web browser. Once in the unit...
Mon, 18 Jan, 2021 at 5:03 PM
When performing a software update on a PAM1 or PAM2 IP, you may encounter one of the following error messages: 'HDI-IP doesn't have a bootloade...
Wed, 5 May, 2021 at 3:26 PM
To update an Embrionix Stick or SFP, please contact TSL Support by emailing [email protected], specifying the module serial number and MAC address whi...
Wed, 5 May, 2021 at 3:26 PM
Navigate to Menu -> Setup -> Setup 2. From Setup 2 select CAT1100 (if you have a CAT552 card this option will be displayed as CAT552). Here you c...
Mon, 17 May, 2021 at 11:21 AM