TallyMan - FAQs
Below is a link to the third party interfaces online spreadsheet, the document contains details of communications and functionality supported by each device...
Mon, 12 Jul, 2021 at 8:03 AM
If your TM1-Mk2 is stuck in the Bootloader mode or only displaying "waiting for firmware" on the front panel, please try the following: Ping the...
Tue, 31 Mar, 2020 at 2:38 PM
For a step by step guide to connecting to a SAM Kula please see the document linked below: Connecting to a TallyMan Kula Note: In order for the T...
Wed, 8 Apr, 2020 at 11:05 AM
1. Default IP Address The default IP address of the TallyMan Controller is: IP Address: 192.168.205.121 Subnet Mask: 255.255.255.0 ...
Wed, 1 Apr, 2020 at 11:32 AM
When connecting TallyMan to a K-frame, a common reason for not being able to connect is not having stated the TallyMan's IP address in the "Tally C...
Wed, 1 Apr, 2020 at 1:39 PM
To connect to Evertz multiviewers TallyMan sends TSL UMD over a UDP connection. Note: A common reason for not being able to connect is that the Evertz M...
Wed, 1 Apr, 2020 at 1:10 PM
Supported control protocols for the MediorNet system from TallyMan, all of these are supported over IP. SW-P-08 Protocol Read and control crosspoints ...
Mon, 6 Apr, 2020 at 2:33 PM
TallyMan can connect to an NV9000 to control and read the crosspoints of any router frame underneath the NV9000 controller. TallyMan can also import names f...
Mon, 6 Apr, 2020 at 12:18 PM
On your .tms configuration file, navigate to the top of the tree and add a new system interface, as seen below: Set the IP address to be the same ...
Wed, 27 Jan, 2021 at 4:57 PM